26
R
OUTE
R
EDISTRIBUTION
C
OMMANDS
The Route Redistribution commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters)
in the following table.
Command Parameters
create route redistribute dst
ospf
src [static/rip/local]
mettype [1/2]
metric <value 0-16777214>
[local | static | ospf {all | internal | external | extType1 | extType2 |
inter+e1 | inter+e2}] {metric <value 0-16>}
src [static/rip/local]
mettype [1/2]
config route redistribute dst
rip
[local | static | ospf {all | internal | external | extType1 | extType2 |
inter+e1 | inter+e2}] {metric <value 0-16>}
delete route redistribute
dst [rip/ospf]
src [local/static/ospf]
show route redistribute
dst [rip/ospf]
src [rip/static/local/ospf]
create route redistribute dst
rip
config route redistribute dst
ospf
metric <value 0-16777214>
Each command is listed, in detail, in the following sections.
create route redistribute dst ospf
Purpose
Used to add route redistribution settings for the exchange of RIP routes
to OSPF routes on the switch.
Syntax
create route redistribute dst ospf src [static|rip|local] {mettype
[1|2]|metric <value 0-16>}
Description
This command will redistribute routing information between the OSPF
and RIP routing protocols to all routers on the network that are running
OSPF or RIP. Routing information entered into the Static Routing Table
on the local DES-6500 switch is also redistributed.
Parameters
src [static/rip/local]
−
Allows for the selection of the protocol for the
source device.
mettype [1/2]
−
Allows for the selection of one of two methods of
calculating the metric value. Type-1 calculates (for RIP to OSPF) by
adding the destination’s interface cost to the metric entered in the Metric
field. Type-2 uses the metric entered in the Metric field without change.
this field applies only when the destination field is OSPF.
metric <value>
−
Allows the entry of an OSPF interface cost. This is
analogous to a Hop Count in the RIP routing protocol.
Restrictions Only
administrator-level users can issue this command.
Routing information source
−
RIP. the Static Route table, and the Local interface routing information. Routing information
will be redistributed to OSPF.
Route Source
Metric
Metric Type
RIP
0 to 16777214
mettype 1
mettype 2
0 to 16777214
mettype 1
Static
Summary of Contents for TM DES-6500
