29
Command Parameters
DNS R
ELAY
C
OMMANDS
The DNS relay commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
config dnsr
primary
secondary
nameserver <ipaddr>
add|delete
static <domain name>
<ipaddr>
enable dnsr
{cache|static}
disable dnsr
{cache|static}
show dnsr
static
Each command is listed, in detail, in the following sections.
config dnsr
Purpose
Used to configure the DNS relay function.
Syntax
config dnsr [[primary/secondary] nameserver <ipaddr>|[add|delete]
static <domain_name> <ipaddr>]
Description
This command is used to configure the DNS relay function on the
switch.
Parameters
primary
−
Indicates that the IP address below is the address of the
primary DNS server.
secondary
−
Indicates that the IP address below is the address of the
secondary DNS server.
nameserver <ipaddr>
−
The IP address of the DNS nameserver.
add|delete – Indicates if the user wishes to add or delete the dns relay
function.
<domain_name>
−
The domain name of the entry.
<ipaddr>
−
The IP address of the entry.
Restrictions Only
administrator-level users can issue this command.
Summary of Contents for TM DES-6500
