LE910-SKG AT commands reference guide
80437ST10619A Rev.1 – 2014-09-16
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 101 of 273
+CGDCONT - Define PDP Context
applicable to the PDP. The allocated address may be read using the
+CGPADDR
command.
<d_comp>
- numeric parameter that controls PDP data compression
0 - off (default if value is omitted)
1 – on
2 - V.42bis
<h_comp>
- numeric parameter that controls PDP header compression
0 - off (default if value is omitted)
1 – on
2 - RFC1144 (applicable for SNDCP only)
3- RFC2507
4- RFC3095 (applicable for PDCP only)
<pd1>
, …,
<pdN>
- zero to N string parameters whose meanings are specific to the
<PDP_type>
Note: a special form of the Set command,
+CGDCONT=<cid>
, causes the values
for context number
<cid>
to become undefined.
AT+CGDCONT?
Read command returns the current settings for each defined context in the format:
+CGDCONT: <cid>,<PDP_type>,<APN>,<PDP_addr>,<d_comp>,
<h_comp>[,<pd1>[,…[,pdN]]][<CR><LF>+CGDCONT: <cid>,
<PDP_type>,<APN>,<PDP_addr>,<d_comp>,<h_comp>
[,<pd1>[,…[,pdN]]][…]]
AT+CGDCONT=?
Test command returns values supported as a compound value
Example
AT+CGDCONT=1,”IP”,
”APN”
,”10.10.10.10”,0,0
OK
AT+CGDCONT?
+CGDCONT: 1,”IP”,“
APN”
,”10.10.10.10”,0,0
OK
AT+CGDCONT=?
+CGDCONT: (1-16),"IP",,,(0-2),(0-4)
+CGDCONT: (1-16),"PPP",,,(0-2),(0-4)
OK
Reference
3GPP TS 27.007
+CGDSCONT - Define Secondary PDP Context
AT+CGDSCONT=
[<cid> ,<p_cid>
[,<d_comp>
[,<h_comp>]]]
Possible response(s):
OK
ERROR
Description:
The set command specifies the PDP context parameter values for a Secondary PDP
context identified by the (local) context Identification parameter, <cid>.
The number of PDP contexts that may be in a defined state at the same time is
Summary of Contents for LE910-SKG
Page 1: ......
