LE910-SKG AT commands reference guide
80437ST10619A Rev.1 – 2014-09-16
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 222 of 273
#GDATAVOL - GPRS Data Volume
format:
#GDATAVOL: <cid
n
>,<tot
n
>,<sent
n
>,<received
n
>[<CR><LF>
#GDATAVOL: <cid
m
>,<tot
m
>,<sent
m
>,<received
m
>[…]]
where:
<cid
n
>
- PDP context identifier
1..5 - numeric parameter which specifies a particular PDP context definition.
(see
+CGDCONT
command)
<tot
n
>
- number of bytes either received or transmitted in the last EPS session
for
<cid
n
>
PDP context;
<sent
n
>
- number of bytes transmitted in the last EPS session for
<cid
n
>
PDP
context;
<received
n
>
- number of bytes received in the last EPS session for
<cid
n
>
PDP
context;
2 - it reports the total EPS data counter, since last reset, for the all the set PDP
contexts (i.e. all the PDP context with APN parameter set using
),
in the format:
#GDATAVOL: <cid
n
>,<tot
n
>,<sent
n
>,<received
n
>[<CR><LF>
#GDATAVOL: <cid
m
>,<tot
m
>,<sent
m
>,<received
m
>[…]]
where:
<cid
n
>
- PDP context identifier
1..5 - numeric parameter which specifies a particular PDP context definition.
(see
+CGDCONT
command)
<tot
n
>
- number of bytes either received or transmitted, in every EPS session
since last reset, for
<cid
n
>
PDP context;
<sent
n
>
- number of bytes transmitted, in every EPS session since last reset, for
<cid
n
>
PDP context;
<received
n
>
- number of bytes received, in every EPS session since last reset,
for
<cid
n
>
PDP context;
Note: last EPS session counters are not saved in NVM so they are loosen at power
off.
Note: total EPS session counters are saved on NVM.
AT#GDATAVOL=?
Test command returns the range of supported values for parameter
<mode>.
Note
#ICMP – ICMP Ping Support
AT#ICMP=<mode>
Set command enables/disables the ICMP Ping support.
Parameter:
<mode>
0 - disable ICMP Ping support (default)
1 - enable firewalled ICMP Ping support: the module is sending a proper
Summary of Contents for LE910-SKG
Page 1: ......
