LE910-SKG AT commands reference guide
80437ST10619A Rev.1 – 2014-09-16
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 242 of 273
#STIA - SIM Tookit Interface Activation
AT#STIA=?
Test command returns the range of available values for the parameters
<mode>
and
<timeout>
.
Note
Just one instance at a time, the one which first issued
AT#STIA=
n
(with
n
different
from zero), is allowed to issue SAT commands, and this is valid till the same
instance issues
AT#STIA=0
.
After power cycle another instance can enable SAT.
Note
A typical SAT session on AT interface starts after an
#STN: 37
unsolicited code is
received, if enabled(see above). At that point usually an
AT#STGI=37
command is
issued (see
and after the SAT main menu has been displayed on TE an
AT#STSR=37,0,x
command is issued to select an item in the menu (see
#STSR)
#STGI - SIM Tookit Get Information
AT#STGI=
[<cmdType>]
#STGI
set command is used to request the parameters of a
proactive command
from the ME.
Parameter:
<cmdType>
-
proactive command
ID according to 3GPP TS 102.223 (decimal);
these are only those command types that use the AT interface; SAT
commands which are not using the AT interface (not MMI related SAT
commands, e.g. PROVIDE LOCAL INFORMATION) are executed
without sending any indication to the user
1 - REFRESH
5 - SET UP EVENT LIST
16 - SET UP CALL
17 - SEND SS
18 - SEND USSD
19 - SEND SHORT MESSAGE
20 - SEND DTMF
32 - PLAY TONE (not supported)
33 - DISPLAY TEXT
34 - GET INKEY
35 - GET INPUT
36 - SELECT ITEM
37 - SET UP MENU
40 - SET UP IDLE MODE TEXT
Requested command parameters are sent using an
#STGI
indication:
#STGI: <parameters>
where
<parameters>
depends upon the ongoing
proactive command
as follows:
if
<cmdType>=1
(REFRESH)
Summary of Contents for LE910-SKG
Page 1: ......
