LE910-SKG AT commands reference guide
80437ST10619A Rev.1 – 2014-09-16
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 257 of 273
#TCPATRUNCLOSE – Closes TCP Run AT Socket
AT#TCPATRUNCLOSE=?
Test command returns
OK
#TCPATCMDSEQ – For TCP Run AT Service, allows the user to give AT commands in sequence
AT#TCPATCMDSEQ=
<mod>
Set command enable/dsable, for TCP Run AT service, a feature that allows
giving more than one AT command without waiting for responses.
It does not work with commands that uses the prompt ‘>’ to receive the
message body text (e.g. “
AT+CMGS
”)
Parameter:
< mod >
0 - Service Disabled (default)
1 - Service Enabled
AT#TCPATCMDSEQ?
Read command returns the current settings of parameters in the format:
#TCPATCMDSEQ: <mod>
AT#TCPATCMDSEQ=?
Test command returns the supported values for the
TCPATCMDSEQ
parameters.
#TCPATCONSER – Connects the TCP Run AT service to a serial port
AT#TCPATCONSER=
<port>,
<rate>
Set command sets the TCP Run AT in transparent mode, in order to have
direct access to the hardware port specified. Data will be transferred directly,
without being elaborated, between the TCP Run AT service and the hardware
port specified.
If the CMUX protocol is running the command will return ERROR.
Parameters:
< port >
0 – UART Main Port
1 – Telit LTE USB Modem1 Port
2 – Telit LTE USB Modem2 Port
Not all of these ports will be available at the same time.
The port available will be displayed by the test command.
<
rate
>
Baud rate for data transfer. Allowed values are
300,1200,2400,4800,9600,19200,38400,57600,115200.
Note: The command has to be issued from the TCP ATRUN instance
Note: After this command has been issued, if no error has occurred, then a
“
CONNECT
” will be returned by the module to advise that the TCP ATRUN
instance is
in online mode
and connected to the port specified.
Summary of Contents for LE910-SKG
Page 1: ......
