LE910-SKG AT commands reference guide
80437ST10619A Rev.1 – 2014-09-16
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 53 of 273
D – Dial
<nr>
- internal phonebook position to be called (See commands
&N
and
&Z
)
Note: LE910KR doesn’t support voice call.
ATD<number>I[;]
ATD<number>i[;]
Issues a call overwriting the CLIR supplementary service subscription default
value for this call
If “
;
” is present a
voice
call is performed.
I
- invocation, restrict CLI presentation
i
- suppression, allow CLI presentation
Note: LE910KR doesn
’t support voice call.
ATD<number>G[;]
ATD<number>g[;]
Issues a call checking the CUG supplementary service information for the current
call. Refer to
+CCUG
command.
If “
;
” is present a
voice
call is performed.
Note: LE910KR doesn’t support voice call.
LE910KR also doesn’t support
+CCUG.
ATD*<gprs_sc>
[*<addr>][*[<L2P>]
[*[<cid>]]]]#
This command is specific of EPS functionality and causes the
MT
to perform
whatever actions are necessary to establish communication between the
TE
and
the external PDN.
Parameters:
<gprs_sc>
- EPS Service Code, a digit string (value 99) which identifies a request
to use the EPS
<addr>
- string that identifies the called party in the address space applicable to
the PDP.
<L2P>
- a string which indicates the layer 2 protocol to be used . For
communications software that does not support arbitrary characters
in the dial string, the following numeric equivalents shall be used:
1 - PPP
<cid>
- a digit which specifies a particular
PDP
context definition (see
+CGDCONT
command).
Example
To dial a number in SIM phonebook entry 6:
ATD>SM6
OK
To have a voice call to the 6-th entry of active phonebook:
ATD>6;
OK
To call the entry with alphanumeric field “Name”:
ATD>”Name”;
OK
Reference
V25ter.
T - Tone Dial
ATT
Set command has no effect is included only for backward compatibility with
Summary of Contents for LE910-SKG
Page 1: ......
