LE910-SKG AT commands reference guide
80437ST10619A Rev.1 – 2014-09-16
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 198 of 273
#SGACTAUTH – Easy GPRS Authentication Type
Note: the parameter is not saved in NVM
AT#SGACTAUTH?
Read command reports the current EPS authentication type, in the format:
#SGACTAUTH: <type>
AT#SGACTAUTH=?
Test command returns the range of supported values for parameter
<type>.
#SGACTCFG – Context Activation and Configuration
AT#SGACTCFG=
<cid>,
<retry>,
[,<delay>
[,<urcmode>]]
Execution command is used to enable or disable the automatic
activation/reactivation of the context for the specified PDP context, to set the
maximum number of attempts and to set the delay between an attempt and the next
one. The context is activated automatically after every
EPS Attach
or after a
NW
PDP CONTEXT deactivation
if al least one IPEasy socket is configured to this
context (see AT#SCFG).
Parameters:
<
cid
> - PDP context identifier.
1..5 – numeric parameter which specifies a particular PDP context definition
(see
+CGDCONT
command)
<
retry
> - numeric parameter which specifies the maximum number of context
activation attempts in case of activation failure. The value belongs to the following
range: 0 – 15
0 – disable the automatic activation/reactivation of the context (default)
<
delay
> - numeric parameter which specifies the delay in seconds between an
attempt and the next one. The value belongs to the following range: 180 – 3600
<
urcmode
> - URC presentation mode
0 – disable unsolicited result code (default)
1 – enable unsolicited result code, after an automatic activation/reactivation, of the
local IP address obtained from the network.
The unsolicited message is in the format:
#SGACT: <ip_address>
Reporting the local IP address obtained from the network.
Note: the URC presentation mode <
urcmode
> is related to the current AT instance
only. Last <
urcmode
> setting is saved for every instance as extended profile
parameter, thus it is possible to restore it even if the multiplexer control channel is
released and set up, back and forth.
Note: <
retry
> and <
delay
> setting aer global parameter saved in NVM.
Summary of Contents for LE910-SKG
Page 1: ......
