LE910-SKG AT commands reference guide
80437ST10619A Rev.1 – 2014-09-16
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 259 of 273
#ENAEVMONI – Enable EvMoni Service
Note: The current settings are stored in NVM.
AT#ENAEVMONI?
Read command returns the current settings of <mode> and the value of <stat>
in the format:
#ENAEVMONI: <mod>,<stat>
where:
<stat>
- service status
0 – not active (default)
1 – active
AT#ENAEVMONI=?
Test command returns the supported values for the
ENAEVMONI
parameters
#ENAEVMONICFG – Set EvMoni Service Parameters
AT#ENAEVMONICFG=
<instance>
[,<urcmod>
[,<timeout>]]
Set command configures the EvMoni service.
Parameters:
<
instance
>
AT instance that will be used by the service to run the AT Command.
Range 1-3. (Default: 3)
Note: In Qualcomm platform, <
instance
> parameter is not supported and
EvMoni service share the same channel with SMS Run AT service. This
parameter is dummy for unified policy.
<urcmod>
0 – disable unsolicited message
1 – enable an unsolicited message when an AT command is executed
after an event is occurred (default)
When unsolicited is enabled, the AT Command is indicated to TE with
unsolicited result code:
#EVMONI: <TEXT>
e.g.:
#EVMONI: AT+CGMRl+CGSN;+GSN;+CCLK
Unsolicited is dumped on the instance that requested the service activation.
<
timeout
>
It defines in minutes the maximum time for a command execution. If timeout
Expires the module will be rebooted. (Default: 5)
Note: The current settings are stored in NVM.
Summary of Contents for LE910-SKG
Page 1: ......
