LE910-SKG AT commands reference guide
80437ST10619A Rev.1 – 2014-09-16
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 230 of 273
#EMAILD - E-mail Sending
..wait..
OK
Message has been sent.
#ESAV - E-mail Parameters Save
AT#ESAV
Execution command saves the actual e-mail parameters in the NVM of the device.
The values stored are:
-
E-mail User Name
-
E-mail Password
-
E-mail Sender Address
-
E-mail SMTP server
AT#ESAV=?
Test command returns the
OK
result code.
Note
If some parameters have not been previously specified then a default value will be
taken.
#ERST - E-mail Parameters Reset
AT#ERST
Execution command resets the actual e-mail parameters in the NVM of the device
to the default ones.
The values reset are:
-
E-mail User Name
-
E-mail Password
-
E-mail Sender Address
-
E-mail SMTP server
AT#ERST=?
Test command returns the
OK
result code.
#EMAILMSG - SMTP Read Message
AT#EMAILMSG
Execution command returns the last response from SMTP server.
AT#EMAILMSG=?
Test command returns the
OK
result code.
#SMTPCL – Send Mail with Attachment
AT# SMTPCL=
<da>,<subj>,<att>
[,<filename>,<encod>
]
This command permits to send an email with different types of attachments if EPS
context has already been activated
(#SGACT, #GPRS).
After sending message body text (as with #EMAILD), the command switch to
online mode if attachment has to be sent.
While in online mode data received on the serial port are transmitted on the SMTP
socket as MIME attachment.
Summary of Contents for LE910-SKG
Page 1: ......
