LE910-SKG AT commands reference guide
80437ST10619A Rev.1 – 2014-09-16
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 112 of 273
+CGACT - PDP Context Activate Or Deactivate
Note: if no
<cid>
s are specified, the activation/deactivation form of the command
activates/deactivates all defined contexts.
Default PDP context(cid 1) is automatically activated by piggybacking on LTE
attach procedure for Always-on IP connectivity. If an attempt is made to disconnect
last PDP conection(cid), MT is just unbinding RM interface to the the last PDP
context.
AT+CGACT?
Read command returns the current activation state for all the defined PDP contexts
in the format:
+CGACT: <cid>,<state>[<CR><LF>+CGACT: <cid>,<state>[…]]
AT+CGACT=?
Test command reports information on the supported PDP context activation states
parameters in the format:
+CGACT: (0,1)
Example
AT+CGACT=1,1
OK
AT+CGACT?
+CGACT: 1,1
OK
Reference
3GPP TS 27.007
+CGPADDR - Show PDP Address
AT+CGPADDR=
[<cid>[,<cid>
[,…]]]
Execution command returns a list of PDP addresses for the specified context
identifiers in the format:
+CGPADDR: <cid>,<PDP_addr>[<CR><LF>+CGPADDR: <cid>,
<PDP_addr>[…]]
Parameters:
<cid>
- a numeric parameter which specifies a particular PDP context definition
(see
+CGDCONT
command). If no
<cid>
is specified, the addresses for all
defined contexts are returned.
<PDP_addr>
- a string that identifies the terminal in the address space applicable
to the PDP. The address may be static or dynamic. For a static
address, it will be the one set by the
+CGDCONT
command when
the context was defined. For a dynamic address it will be the one
assigned during the last PDP context activation that used the
context definition referred to by
<cid>
;
<PDP_addr>
is omitted if
none is available
AT+CGPADDR=?
Test command returns a list of defined
<cid>
s.
Example
AT#SGACT=1,1
+IP: xxx.yyy.zzz.www
OK
Summary of Contents for LE910-SKG
Page 1: ......
