LE910-SKG AT commands reference guide
80437ST10619A Rev.1 – 2014-09-16
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 143 of 273
#REBOOT - Reboot
Example
AT#REBOOT=?
OK
AT#REBOOT
OK
#Z - Extended reset
AT#Z=<profile>
Set command loads both base section and extended section of the
specified user profile stored with AT&P.
Parameter
<profile>
0 – user profile 0
1 – user profile 1
AT#Z=?
Test command tests for command existence.
#ENHRST – Periodic ReseT
AT#ENHRST=<mod
>[,<delay>]
Set command enables/disables the unit reset after <
delay
> minutes.
Parameters:
<
mod
>
0 – disables the unit reset (factory default)
1 – enables the unit reset only for one time
2 – enables the periodic unit reset
<
delay
> - time interval after that the unit reboots; numeric value in minutes
Note: the settings are saved automatically in NVM only if old or new mod is 2.
Any change from 0 to 1 or from 1 to 0 is not stored in NVM
Note: the particular case AT#ENHRST=1,0 causes the immediate module reboot.
In this case if AT#ENHRST=1,0 follows an AT command that stores some
parameters in NVM, it is recommended to insert a delay of at least 5 seconds
before to issue AT#ENHRST=1,0, to permit the complete NVM storing.
Note: maximum <
delay
> value is 2184 mins
AT#ENHRST?
Read command reports the current parameter settings for # EHNRST command in
the format:
#
EHNRST
: <
mod
>[,<
delay
>,<
remainTime
>]
<
remainTime
> - time remaining before next reset
AT#ENHRST=?
Test command reports supported range of values for parameters <
mod
> and
Summary of Contents for LE910-SKG
Page 1: ......
