LE910-SKG AT commands reference guide
80437ST10619A Rev.1 – 2014-09-16
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 264 of 273
#CMGS - Send Message
where
<mr>
- message reference number; 3GPP TS 23.040 TP-Message-Reference
in integer format.
Note: if message sending fails for some reason, an error code is reported.
AT#CMGS=?
Test command resturns the
OK
result code.
Note
To avoid malfunctions is suggested to wait for the
#CMGS: <mr>
or
#CMS
ERROR: <err>
response before issuing further commands.
Reference
GSM 27.005
#CMGW - Write Message To Memory
(PDU Mode)
AT#CMGW=
<length>,<pdu>
(PDU Mode)
Execution command writes in the
<memw>
memory storage a new message.
Parameter:
<length>
- length in bytes of the PDU to be written.
7..164
<pdu>
- PDU in hexadecimal format (each octet of the PDU is given as two
IRA character long hexadecimal number) and given in one line.
If message is successfully written in the memory, then the result is sent in the
format:
#CMGW: <index>
where:
<index>
- message location index in the memory
<memw>
.
If message storing fails for some reason, an error code is reported.
(Text Mode)
AT#CMGW=<da>
,<text>
(Text Mode)
Execution command writes in the
<memw>
memory storage a new message.
Parameters:
<da>
- destination address, string type represented in the currently selected
character set (see
+CSCS
).
<text>
- text to write
The entered text should be enclosed between double quotes and formatted as
follows:
- if current
<dcs>
(see
+CSMP
) indicates that GSM03.38 default alphabet is
used and current
<fo>
(see
+CSMP
) indicates that 3GPP TS 23.040 TP-
Summary of Contents for LE910-SKG
Page 1: ......
