LE910-SKG AT commands reference guide
80437ST10619A Rev.1 – 2014-09-16
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 256 of 273
#TCPATRUNAUTH – TCP AT Run Authentication Parameters List
#TCPATRUNAUTH: <userid>,<passw>
…
OK
AT#TCPATRUNAUTH=
?
Test command returns the allowed values for parameter <
action
>.
#TCPATRUND – Enable TCP AT Run Service in dial (client) mode
AT#TCPATRUND=
<mod>
Set command enables/disables the TCP AT RUN service in client mode.
When this service is enabled, the module tries to open a connection to the Host
(the Host is specified in
AT#TCPATRUNCFG
).
Parameter:
< mod >
0: Service Disabled
1: Service Enabled
Note: The current setting are stored in NVM
Note: To start automatically the service when the module is powered-on, the
automatic PDP context activation has to be set (see
AT#SGACTCFG
command).
Note: If the connection closes or at boot, if service is enabled and context is
active, the module will try to reconnect for the number of attempts specified in
AT#TCPATRUNCFG also the delay between one attempt and the other will be
the one specified in
AT#TCPATRUNCFG
.
AT#TCPATRUND?
Read command returns the current settings of <
mode
> and the value of <
stat
> in
the format:
# TCPATRUND: <mod>,<stat>
where:
<stat>
- connection status
0 – not connected
1 – connected or connecting at socket level
2 – not connected but still trying to connect, attempting every delay time
(specified in
AT#TCPATRUNCFG
)
AT#TCPATRUND =?
Test command returns the supported values for the
TCPATRUND
parameters
#TCPATRUNCLOSE – Closes TCP Run AT Socket
AT#TCPATRUNCLOSE
Closes the socket used by TCP ATRUN service.
Note: TCP ATRUN status is still enabled after this command, so the service
re-starts automatically.
Summary of Contents for LE910-SKG
Page 1: ......
