LE910-SKG AT commands reference guide
80437ST10619A Rev.1 – 2014-09-16
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 172 of 273
#NWSCANTMR - Network Scan Timer
AT#NWSCANTMR
Execution command reports time, in seconds, when the next scan activity
will be executed. The format is:
#NWSCANTMREXP: <time>
Note: if
<time>
is zero it means that the timer is not running
AT#NWSCANTMR?
Read command reports the current parameter setting for
#NWSCANTMR
command in the format:
#NWSCANTMR: <tmr>
AT#NWSCANTMR=?
Test command reports the supported range of values for parameter
<tmr>
Note
How much time it takes to execute the network scan depends either on how
much bands have been selected and on network configuration (mean value
is 5 seconds)
#HWREV – Hardware revision
AT#HWREV
Execution command returns the device Hardware revision identification code without
command echo.
AT#HWREV=?
Test command returns the
OK
result code.
#CDORM – Dormant Control Command
AT#CDORM=
<action>
[,<cal_id>]
Set command used to:
1. Enable/Disable the indication of dormant mode.
2. Fast dormancy
3. Exit from dormancy.
When the indication is enabled, an unsolicited report with the current
status(dormant or active) per packet call will be sent to the DTE. Then, an update
report sent to the DTE each time a change detected on status.
Parameters:
<action>
-
0 - Disable the dormant status unsolicited result code.
1 - Enable the dormant status unsolicited result code
#CDORM: <call_id>,<dormant_status>
Where:
<dormant_status>
-
0 call is in dormant mode
1 call is in active mode
2 - Go to dormant (fast dormancy)
3 - Exit dormant for
<call_id>
or first found call id if no
<call_id>
mentioned.
<call_id>
- Integer type, call identification number.
Range from 0 to 18. (only for Exit dormancy action)
AT#CDORM?
The read command returns the current settings and status.
Summary of Contents for LE910-SKG
Page 1: ......
