LE910-SKG AT commands reference guide
80437ST10619A Rev.1 – 2014-09-16
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 225 of 273
#NWDNS – DNS from Network
AT#NWDNS=?
Test command returns a list of defined
<cid>
s.
#SMSMOVE – Move Short Message To Other Memory
AT#SMSMOVE=
<index>
Execution command moves selected Short Message from current memory to
destination memory.
Parameter:
<index>
- message index in the memory selected by
+CPMS
command. It can have
values form 1 to N, where N depends on the available space (see
+CPMS
)
Note: if the destination memory is full, an error is returned.
AT#SMSMOVE?
Read command reports the message storage status of the current memory and the
destination memory in the format:
#SMSMOVE:
<curr_mem>,<used_curr_mem>,<total_curr_mem>,<dest_mem>,<used_dest_
mem>,<total_dest_mem>
Where:
-
<curr_mem>
is the current memory, selected by
+CPMS
command. It can
assume the values
“SM”
or
“ME”
-
<used_curr_mem>
is the number of SMs stored in the current memory
-
<total_curr_mem>
is the max number of SMs that the current memory can
contain
-
<dest_mem>
is the destination memory. It can assume the values
“SM”
or
“ME”
-
<used_dest_mem>
is the number of SMs stored in the destination memory
-
<total_dest
AT#SMSMOVE=?
Test command reports the supported values for parameter
<index>
Example
AT+CPMS="ME"
+CPMS: 3,100,0,20,0,20
OK
AT#SMSMOVE?
#SMSMOVE: "ME",3,100,"SM",0,50
OK
//the current memory is ME where 3 SMs are stored; the destination memory is SIM
that is empty
AT+CMGL=ALL
+CMGL: 1,"STO UNSENT","32XXXXXXXX","",
test 1
+CMGL: 2,"STO UNSENT","32XXXXXXXX","",
test 2
+CMGL: 3,"STO UNSENT","32XXXXXXXX","",
test 3
Summary of Contents for LE910-SKG
Page 1: ......
