LE910-SKG AT commands reference guide
80437ST10619A Rev.1 – 2014-09-16
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 211 of 273
#DSTO -Data Sending Time-Out
Note: this time-out applies to data whose size is less than packet size and whose
sending would have been delayed for an undefined time until new data to be sent
had been received and full packet size reached.
AT#DSTO?
Read command reports the current data sending time-out value.
AT#DSTO=?
Test command returns the allowed values for the parameter
<tout>
.
Example
AT#DSTO=10
->1 sec. time-out
OK
AT#DSTO?
#DSTO: 10
OK
#SKTTO - Socket Inactivity Time-Out
AT#SKTTO=
[<tout>]
Set command sets the maximum time with no data exchanging on the socket that
the module awaits before closing the socket and deactivating the EPS context.
Parameter:
<tout>
- socket inactivity time-out in seconds units
0 - no time-out.
1..65535 - time-out in sec. units (factory default is 90).
Note: this time-out applies when no data is exchanged in the socket for a long time
and therefore the socket connection has to be automatically closed and the EPS
context deactivated.
AT#SKTTO?
Read command reports the current socket inactivity time-out value.
AT#SKTTO=?
Test command returns the allowed values for parameter
<tout>
.
Example
AT#SKTTO=30
OK
->(30 sec. time-out)
AT#SKTTO?
#SKTTO: 30
OK
#SKTSET - Socket Definition
AT#SKTSET=
[<socket type>,
<remote port>,
<remote addr>,
[<closure type>],
[<local port>]]
Set command sets the socket parameters values.
Parameters:
<socket type>
- socket protocol type
0 - TCP (factory default)
1 - UDP
<remote port>
- remote host port to be opened
1..65535 - port number (factory default is 3333)
<remote addr>
- address of the remote host, string type. This parameter can be
Summary of Contents for LE910-SKG
Page 1: ......
