controller dwdm
To configure a DWDM controller, use the
controller dwdm
command in Global Configuration mode. To
return to the default state, use the
no
form of this command.
controller dwdm interface-path-id
no controller dwdm interface-path-id
Syntax Description
Physical interface or virtual interface.
Use the
show interfaces
command to see a list of all interfaces currently
configured on the router.
Note
For more information about the syntax for the router, use the question mark (
?
) online
help function.
interface-path-id
Command Default
No default behavior or values
Command Modes
Global Configuration mode
Command History
Modification
Release
This command was introduced.
Release 3.9.0
Usage Guidelines
For the
interface-path-id
argument, use the following guidelines:
•
If specifying a physical interface, the naming notation is
rack
/
slot
/
module
/
port
/
subport
. The slash between
values is required as part of the notation. An explanation of each component of the naming notation is
as follows:
◦
rack
: Chassis number of the rack.
◦
slot
: Physical slot number of the line card.
◦
module
: Module number.
◦
port
: Physical port number of the interface.
◦
subport
: Physical port number of the sub-interface.
•
If specifying a virtual interface, the number range varies, depending on interface type.
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
5
Dense Wavelength Division Multiplexing Commands on the Cisco ASR 9000 Series Router
controller dwdm
