Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
3-22
GR2K-GA-0014
Ver. 07-02
Show the registration status of RMON event-group entry:
Delete registered RMON Ethernet event-group entry with the event-group index
number 3, and show the resulting event-group entries:
Related Configuration Objects
alarm
snmp
Related Information
The MIB value of an RMON Ethernet history group can be referenced using an SNMP
manager or this router’s
snmp
command. For the
snmp
command, refer to
GR2000
Operations Commands, Vol. 1
.
Precautions
1. In order to access the Ethernet event-group information from an SNMP Manager
or issue a trap to an SNMP Manager, you must register the SNMP Manager. For
the latter purpose, specify
-trap
or
-ex_trap
option in the registration action.
2. Make sure that the
rising_event_index
and
falling_event_index
settings are equal to
those defined by the
alarm
object. If any discrepancy exists, the event is not
executed in response to an alarm.
3. Make sure that the
community
setting is equal to the one defined by the
snmp
object. If any discrepancy exists, no trap is transmitted in the specified event.
4. When RMON eventTable is sent from an SNMP Manager, the change is not
reflected in the router’s configuration.
5. If this command is inputted in the cases where changes are made on the IP
routing protocol information, the IP multicast protocol information, and the
MPLS information, and the
apply
command is not being executed, the
apply
subcommand is executed before the command is executed, and the changed IP
routing protocol information, IP multicast routing protocol information, and
MPLS information are reflected to the operation.
(config)# show event
event 3 {
type trap;
community "rmon-mgr";
description "if inInError > 200 then trap";
owner "monitor";
};
event 5 {
type log;
owner "net-mgr ichiro 07/25";
};
(config)#
(config)# delete event 3
(config)# show event
event 5 {
type log;
owner "net-mgr ichiro 07/25";
};
(config)#