IP CLI Commands
2/1553-ZAT 759 94 Uen B – December 2005
289
12.32
ip set rip hostroutes
12.32.1 Syntax
ip set rip hostroutes {enabled|disabled}
12.32.2 Description
This command specifies whether IP interfaces will accept RIP routes to
specific routes.
Note:
RIP version 1 does not allow specification of subnet masks; a RIP
version 1 route that appears to be to an individual host might in fact be
to a subnet, and treating it as a route to the whole network may be the
best way to make use of the information.
To display the current state of rip hostroutes, use the
ip show
command.
12.32.3 Options
The following table gives the range of values for each option which can be
specified with this command and a default value (if applicable).
Option Description
Default
value
enabled
Sets the hostroutes flag to on. The
interface accepts RIP routes to
specific routes.
disabled
Sets the hostroutes flag to off.
RIP version 1 routes to individual
hosts are treated as routes to the
network containing the host.
RIP version 2 routes to individual
hosts are ignored.
disabled
12.32.4 Example
-->
ip set rip hostroutes enabled