Security CLI Commands
2/1553-ZAT 759 94 Uen B – December 2005
575
19.31 security
show
trigger
19.31.1 Syntax
security show trigger <name>
19.31.2 Description
This command displays information about a single trigger that was added to
the Security module using the security add trigger command. The following
trigger information is displayed:
•
Trigger
name.
•
Transport type (TCP or UDP).
•
Start of the port range.
•
End of the port range.
•
Multiple host permission (true or false).
•
Maximum activity interval (in milliseconds).
•
Session chaining permission (true or false).
•
Session chaining on UDP permission (true or false).
•
Binary address replacement permission (true or false).
•
Address translation type (UDP, TCP, none or both).
19.31.3 Options
The following table gives the range of values for each option which can be
specified with this command and a default value (if applicable).
Option Description
Default
value
name
A name that identifies an existing
trigger. To display trigger names, use
the
security list triggers
command.
N/A
19.31.4 Example
-->
security show trigger t1
Security Trigger: t1