Remote Control Commands
R&S
®
SMA100B
464
User Manual 1178.3834.02 ─ 03
Parameters:
<LTerminator>
STANdard | EOI
EOI
Recognizes an LF (Line Feed) as the terminator only when it is
sent with the line message EOI (End of Line). This setting is rec-
ommended particularly for binary block transmissions, as binary
blocks may coincidentally contain a characater with value LF
(Line Feed), although it is not determined as a terminator.
STANdard
Recognizes an LF (Line Feed) as the terminator regardless of
whether it is sent with or without EOI.
*RST:
n.a. (factory preset: STANdard)
Example:
See
Example "Finding out the used VISA ressource strings"
:SYSTem:COMMunicate:GPIB:RESource?
Queries the visa resource string for remote control via the GPIB interface.
To change the GPIB address, use the command
.
Return values:
<Resource>
string
Example:
See
Example "Finding out the used VISA ressource strings"
Usage:
Query only
:SYSTem:COMMunicate:GPIB[:SELF]:ADDRess
<Address>
Sets the GPIB address.
Parameters:
<Address>
integer
Range:
0 to 30
*RST:
28
Example:
See
Example "Finding out the used VISA ressource strings"
:SYSTem:COMMunicate:HISLip:RESource?
Queries the VISA resource string . This string is used for remote control of the instru-
ment with HiSLIP protocol.
Return values:
<Resource>
string
SYSTem Subsystem
