Remote Control Commands
R&S
®
SMA100B
440
User Manual 1178.3834.02 ─ 03
Example:
// increasing the RF level with a step size of 2 dB
SOURce1:POWer:STEP:INCRement 2
SOURce1:POWer:STEP:MODE USER
SOURce1:POWer:LEVel:IMMediate:AMPLitude UP
Manual operation:
See
[:SOURce<hw>]:POWer:STEP[:INCRement]
<Increment>
Specifies the step width in the appropriate path for
To adjust the level step-by-step with this increment value, use the command
.
Note:
The command also sets "Variation Step" in the manual control, that means the
user-defined step width for setting the level with the rotary knob or the UP/DOWN
arrow keys.
Parameters:
<Increment>
float
Range:
0 to 100
Increment: 0.01
*RST:
1
Default unit: dB
Example:
See
Manual operation:
See
[:SOURce<hw>]:POWer[:LEVel][:IMMediate]:OFFSet
<Offset>
Sets the level offset of a downstream instrument.
The level at the RF output is not changed.
To query the resulting level, as it is at the output of the downstream instrument, use the
command
[:SOURce<hw>]:POWer[:LEVel][:IMMediate][:AMPLitude]
.
See
"RF frequency and level display with a downstream instrument"
Note:
The level offset also affects the RF level sweep.
Parameters:
<Offset>
float
Range:
-100 to 100
Increment: 0.01
*RST:
0
Default unit: dB
Level offset is always expreced in dB; linear units (V, W, etc.)
are not supported
Example:
POWer:OFFSet 10
Sets the RF level offset to 10 dB
Manual operation:
See
SOURce Subsystem
