Remedy:
Causes of error: See error code %4
A -> Plausibility of the input points PM1, PM2, PM3 not fulfilled, resulting side lengths must not be equal to zero
(Notice: even in the case of side lengths not equal to zero, there is a risk of not being able
to form a triangle => check PM1...3!)
B -> Enclosed angle at PM1 between the spread vectors PM1PM2 and PM1PM3 is equal to 0.
Starting points do not form a triangle.
C -> Enclosed angle at PM2 between the spread vectors PM2PM1 and PM2PM3 is equal to 0.
Starting points do not form a triangle.
D -> Enclosed angle at PM3 between the spread vectors PM3PM1 and PM3PM2 is equal to 0.
Starting points do not form a triangle.
E -> Normalizing interpolation point: Invalid axis name defined for computation
F -> Normalizing interpolation point: Invalid plane defined for computation
G -> If the computed angle is larger than the limiting value of the angular segment of the rotary axis
in parameter _TNVL. The computed limit angle and the name of the rotary axis are displayed.
With values of _TNVL < 20 degrees, inaccuracies are to be expected as a result of measuring inaccuracies
in the micrometer range of the probe.
Example: "61429 .. G Axis:C->TVLmin=12.345"
Remedy: Adjust angular value of rotary axis in user program or parameter _TNVL.
Note regarding 840 Dsl sb SW 4.7. Sp1
With complete measurement of kinematics with CYCLE9960, the value for the limit angles is entered
in SD $SCS_MEA_KIN_MIN_ANG_TRIANGLE (minimum interal angle of the measuring triangle)
"CC Option ? " -> Option compile cycle "Measurement of kinematics" not set
"$MN_CC_ACTIVE_IN_CHAN_C996[0] ? " -> machine data for compile cycle not set
"License ? " -> License for "Measurement of kinematics" not set
For 840D sl - as from SW 4.7 SP1:
When measuring head kinematics without offset (spindle extension), an alternative calculation is performed with error
message A or G. This shall apply on condition that the rotary axis to be measured has been repositioned
H -> Conditions for alternative calculation not fulfilled (rotary asis not positioned -> see _OVR[60] to _OVR]62]
or SD55648 $SCS_MEA_KIN_MIN_ANG_POS smaller than the difference of the rotary axis positions in _OVR[60]
to _OVR]62]
I -> Conditions for alternative calculation not fulfilled (rotary axis not positioned -> see _OVR[60] to _OVR]62]
61440
[Channel %1: ] Block %2: Position of cutting edge cannot be determined
Parameters:
%1 = Channel number
%2 = Block number, label channel number
Explanation:
Remedy:
A turning tool with a cutting edge position between 1 and 8 must be used as the tool type.
Check the entered cutting edge position with reference to the basic position of the tool carrier.
61441
[Channel %1: ] Block %2: Position of cutting edge is not in the machining plane.
Parameters:
%1 = Channel number
%2 = Block number, label channel number
Explanation:
Remedy:
The position of the cutting edge of the turning tool (cutting tip) is no longer in the machining plane (interpolation plane),
this can be caused, for example, by a tool carrier with orientation capability. Correct the tool carrier position.
61442
[Channel %1: ] Block %2: Tool carrier not parallel to the geometry axes
Parameters:
%1 = Channel number
%2 = Block number, label channel number
Explanation:
SINUMERIK 808D ADVANCED alarms
5.3 Cycle alarms
Diagnostics Manual
Diagnostics Manual, 06/2015, 6FC5398-6DP10-0BA2
449
