12200
[Channel %1: ] Block %2 symbol %3 cannot be created
Parameters:
%1 = Channel number
%2 = Block number, label
%3 = Symbol in the source block
Explanation:
The symbol to be created with the DEF instruction cannot be created because:
- it has already been defined (e.g. as variable or function)
- the internal memory location is no longer sufficient (e.g. with large arrays)
Reaction:
Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy:
Make the following checks:
- Check with the text editor whether the name to be allocated in the active program cycle (main program and called
subprograms) has already been used.
- Estimate the memory requirements for the symbols already defined and reduce these if necessary by using fewer global
and more local variables.
Programm
continuation:
Clear alarm with NC START or RESET key and continue the program.
12205
[Channel %1: ] Block %2 area specification missing for GUD area
Parameters:
%1 = Channel number
%2 = Block number, label
Explanation:
The area specification
(NCK or CHAN) was not programmed in the definition instruction for a GUD variable.
Reaction:
Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy:
Complete the area specification for the GUD variable definition in the GUD definition file.
The definition of a GUD variable must conform to the following syntax:
DEF <Area> <Data type> <Variable name> e.g.
DEF NCK INT intVar1
DEF CHAN REAL realVar1
Programm
continuation:
Clear alarm with NC START or RESET key and continue the program.
12210
[Channel %1: ] Block %2 string %3 too long
Parameters:
%1 = Channel number
%2 = Block number, label
%3 = String in the source block
Explanation:
- In the definition of a STRING type variable, an attempt has been made to initialize more than 200 characters.
- In an allocation, it has been found that the string does not fit the given variable.
- In synchronized actions, a string with more than 31 characters has been programmed.
Reaction:
Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy:
Press the NC Stop key and select the "Correction block" function with the PROGRAM CORRECT softkey. The cursor is
positioned on the incorrect block.
- Select a shorter string or divide the character string into 2 strings.
- Define a longer string variable.
- Restrict the string to 31 characters.
Programm
continuation:
Clear alarm with NC START or RESET key and continue the program.
SINUMERIK 808D ADVANCED alarms
5.2 NCK alarms
Diagnostics Manual
Diagnostics Manual, 06/2015, 6FC5398-6DP10-0BA2
147
