UMN:CLI
User Manual
V8102
110
To remove the configured actions, use the following command.
Command
Mode
Description
no fault-monitor daemon NAME
fault-type
{
crash
|
timeout
}
action
Global
Deletes the configured actions.
no fault-monitor daemon NAME
threshold
Deletes the configured threshold value and returns to
the default setting.
no fault-monitor inspect-interval
Deletes the configured interval for inspection and re-
turns to the default setting.
no
fault-monitor
startup-
threshold
Deletes the configured startup-threshold and returns to
the default setting..
To display the current fault monitoring status of all daemons, use the following command.
Command
Mode
Description
show fault-monitor
Global
Shows the current fault monitoring status of all dae-
mons.
5.7.3
Data Synchronization between SFUs
If there are dual SFUs in V8102 chassis, the currently saved configuration data of active
SFU can be copied and moved to standby SFU. To synchronize the configuration data be-
tween SFUs for redundancy control, use the following command.
Command
Mode
Description
copy configsync all
Enable
Copies the entire configuration files of active SFU and
send them to the standby SFU.
copy configsync partial FILE-
NAME
Copies a configuration file to a specified file name.
FILENAME: configuration file name
The user can not set any configuration on the standby SFU by default. To enable/disable
a standby SFU to be configured by CLI, use the following command.
Command
Mode
Description
red-config-standby enable
Enable
Enables a standby SFU to be configured by CLI.
red-config-standby disable
Disables a standby SFU to be configured by CLI.
