UMN:CLI
User Manual
V8102
848
13.6.2
TPID Configuration
To configure the specific TPID value for operations on the input (filtering) side and output
(tagging) side of the table, use the following command.
Command
Mode
Description
tpid
{
input VALUE
|
output VAL-
UE
}
GPON-ext-
vlan-oper
Configures the specific TPID value for operations on
the input (filtering) side and output (tagging) side of the
table.
VALUE: TPID
no tpid
{
input
|
output
}
Deletes the configured TPID value.
13.6.3
Downstream Mode Configuration
Although the extended VLAN tagging operation pertains to upstream traffic, this configu-
ration specifies the mode for downstreaming mapping.
The operation performed in the downstream direction is the inverse of that performed in
the upstream direction. For one-to-one VLAN mappings, the inverse is trivially defined.
Many-to-one mappings are possible, however, and these are treated as follows. If the
many-to-one mapping results from multiple operation rules producing the same ANI-side
tag configuration, then the first rule in the list defines the inverse operation. If the many-
to-one mapping results from
“do not care” fields in the filter being replaced with provi-
sioned fields in the ANI-side tags, then the inverse is defined to set the corresponding
fields on the ANI-side with their lowest value.
To enable/disable the extended VLAN tagging operation for the downstream mode, use
the following command.
Command
Mode
Description
downstream-mode
{
enable
|
disable
}
GPON-ext-
vlan-oper
Enables/disables the extended VLAN tagging operation
for the downstream mode.
13.6.4
Saving and Applying Profile
After configuring an profile, you need to save the profile with the following command.
Command
Mode
Description
apply
GPON-ext-
vlan-oper
Saves an profile configuration.
Whenever you modify the profile, you should apply the changes again using the
apply
command. If you do not, it will not be applied.
i