User Manual
UMN:CLI
V8102
747
13.1.14
ONU RX-Power Update
To configure the interval of ONU rx-power update, use the following command.
Command
Mode
Description
onu rx-power update
{<1-1440> |
disable
}
Global
Configures the interval of ONU rx-power update.
1-1440: interval (unit: minute)
disable: do not update
To display the configuration of ONU rx-power update, use the following command.
Command
Mode
Description
show onu rx-power update
Enable
Global
Interface
[GPON]
Shows the configuration of ONU rx-power update.
To display the received signal power information from an ONU, use the following com-
mand.
Command
Mode
Description
show olt rx-power gpon OLT-ID
[
ONU-ID
]
Enable
Global
Shows OLT RX signal power from all ONUs.
show olt rx-power
Enable
Global
Shows the configuration of OLT rx-power update.
show olt rx-power
[
ONU-ID
]
Interface
[GPON]
Shows OLT RX signal power from an ONU.
13.1.15
Configurations for RF Return Packet Forwarding
In case the ONUs are connected with the set-top-boxes supporting Ethernet return path
capabilities, GPON OLT can use Ethernet for the return path to head-end infrastructure.
Deploying an ONU/MDU with an RF to Ethernet converter enables RF-digital-RF conver-
sion. At the ONU, the upstream return path packet is carried in GPON OLT. The GPON
OLT aggregates the packets from the ONUs and sends them to the Ethernet to RF con-
verter as the head-end node. This RF converter converts the Ethernet signals to back to
RF signal.
To specify the destination MAC address, ethertype, and VLAN ID for the head-end node
on the connection to send RF return path traffic, use the following command.
Command
Mode
Description
onu rf-pw dst-mac MACADDR
Global
Sets the destination MAC address of RF return path
modulator
’s FPGA.
onu rf-pw ethtype TYPE-NUM
Sets the ethernet type and VLAN ID for RF return path
traffic forwarding.
TYPE-NUM: ethernet type (e.g. 0x8864 - PPPoE)
onu rf-pw vid
<1-4094>
