UMN:CLI
User Manual
V8102
394
To define the behavior on a specified port when a loop is occurred, use the following
command.
Command
Mode
Description
loop-detect
block
Interface
[XE/GE/GPON/CG]
Enables the blocking option. This configures
a specified port to automatically change its
state to BLOCKED when a loop is detected
on it. (default: disable)
loop-detect
unblock
Forces the state of a blocked port to change
to NORMAL.
loop-detect
timer
<0-86400>
Sets the interval of changing the state of a
blocked port to NORMAL.. If you set the
interval as 0, the state of the blocked port will
not be changed automatically.
(default: 600 seconds)
no loop-detect
block
Disables the blocking option.
To set the interval of sending the loop-detecting packet, use the following command.
Command
Mode
Description
loop-detect
period
<1-60>
Interface
[XE/GE/GPON/CG]
Sets the interval of sending the loop-
detecting packet.
(default: 30 seconds)
To display a current configuration of the loop detection, use the following command.
Command
Mode
Description
show
loop-detect
{
all
|
summary
}
Enable
Global
Interface
[XE/GE/GPON/CG]
Shows the brief information of the loop de-
tection.
The loop detection cannot operate with LACP.
!