User Manual
UMN:CLI
V8102
527
10.3.2.8
PIM Static Join
The IGMP static join feature supports an IGMPv2 host only. PIM static join has been also
developed to reduce the zapping time by statically creating a virtual host that behaves like
a real on a port. However, IGMP static join feature can not be used by Layer 3 device
(Core switch) that is incapable of IGMP feature with no group member (host). In this case,
you can use PIM static join instead of IGMP static join.
To configure the PIM static join, use the following command.
Command
Mode
Description
ip pim static-group
A.B.C.D
Interface
[loopback
/VLAN]
Configures the PIM static join.
A.B.C.D: Start/End multicast group ad-
dress
ip pim static-group range
A.B.C.D
A.B.C.D
no ip pim static-group
[
A.B.C.D
| *]
Deletes the configured PIM static join.
*: all addresses
no ip pim static-group
range
A.B.C.D
A.B.C.D
10.3.2.9
Bootstrap Messages (BSM) Support
To enable support for sending and receiving unicast Bootstrap Messages (BSM) on an in-
terface, use the following command.
Command
Mode
Description
ip pim unicast-bsm
Interface
[loopback
/VLAN]
Enables unicast bootstrap messages.
no ip pim unicast-bsm
Disables unicast bootstrap messaging on
an interface.
10.3.2.10
Propagation Delay Configuration
To configure a propagation delay value for PIM, use the following command.
Command
Mode
Description
ip pim propagation-delay
<1000-5000>
Interface
[loopback
/VLAN]
Configures the propagation delay value.
1000-5000: range of values for propaga-
tion delay in milli-seconds. (default: 500)
no ip pim progagation-delay
Returns the propagation delay to its de-
fault value.
10.3.2.11
Displaying PIM Information
To display current PIM information, use the following command.
Command
Mode
Description
show ip pim interface
[
detail
]
Enable
Global
Shows PIM interface information.
detail: includes VIF information
show ip pim local-members
[
INTERFACE
]
Shows PIM local membership information.
show ip pim mroute A.B.C.D
Shows the multicast routing table.
