User Manual
UMN:CLI
V8102
833
22.5)
line-length
power-feed
ds3-
power line-length
{
225
|
450
}
Specifies the length of coaxial cable from a DS3 physi-
cal UNI to the DSX-3 cross-connect point.
ds3-power: DS3 power feed
225/450: line length (unit: ft) (225: 0 to 225, 450: 226 to
450)
no line-length
Deletes the configured line length.
13.4.7.5
DS1 Mode
To specify the mode of DS1, use the following command.
Command
Mode
Description
ds1-mode connect ds1-cpe line-
length
{
short
|
long
}
Traffic-CES
Specifies the mode of DS1.
ds1-cpe: DS1 CPE (loopback: smart jack)
ds1-niu-cpe: DS1 NIU CPE (loopback: intelligent office
repeater)
short: line length - short haul
long: line length - long haul
no-power: no power feed
with-power: with power feed
ds1-mode connect ds1-niu-cpe
power
{
no-power
|
with-power
}
no ds1-mode
Deletes the configured DS1 mode.
13.4.7.6
Line Type
To specify the line type used in DS3 or E3 application, use the following command.
Command
Mode
Description
line-type
{
other
|
ds3-m23
|
ds3-
syntran
|
ds3-cbit-parity
|
ds3-
clear-channel
|
e3-framed
|
e3-
plcp
}
Traffic-CES
Specifies the line type used in a DS3 or E3 application.
(mandatory for DS3 and E3 interfaces, not applicable
to other interfaces)
13.4.7.7
TDM Service Configuration
In order to configure TDM service, you need to create an TDM service ID.
To create the TDM service ID and enter the configuration mode for the service, use the
following command.
Command
Mode
Description
tdm-service SERVICE_ID mode
{
pw-ip
|
pw-mef8
|
pw-mpls
}
Traffic-CES
Creates a TDM service ID and enters the configuration
mode for the service.
pw-ip: pseudowire IP transport (UDP/IP)
pw-mef8: pseudowire MEF8
pw-mpls:
pseudowire MPLS