User Manual
UMN:CLI
V8102
783
OAM allows both unicast and multicast loopback. Ethernet Traceroute function is used to
retrieve adjacency relationship between a MEP and a remote MEP or MIP. And it is also
used for fault localization. The V8102 sends LinkTrace Message (LTM) frames to discover
a path for a link trace.
To configure the source / destination MEP to send the LoopBack Message (LBM) or Link-
Trace message (LTM), use the following command.
Command
Mode
Description
onu cfm test loopback ONU_ID mep
{
uni eth PORT
|
ani mapper PORT
}
mep-id MEP_ID
{
rmep-id
<1-8191> |
rmac MACADDR
}
[
count
NUMBER
]
Interface
[GPON]
Performs the Loopback/Traceroute test for ONU
and specifies MEP ID and remote MEP ID/ MAC
address to send LBM/LTM from the ONU.
ONU_ID: ONU ID (1 to128) or ONU serial number
PORT: ONU
’s UNI Ethernet port number or ANI
mapper port number
MEP_ID: MEP ID
1-8191: destination MEP ID
MACADDR: destination MAC address to send
LBMs/LTMs
NUMBER: the number of attempts for sending
LBMs (default:1)
1-64: LBM/LTM
’s TTL value (default: 64)
onu cfm test traceroute ONU_ID
mep
{
uni eth PORT
|
ani mapper
PORT
}
mep-id MEP_ID
{
rmep-id
<1-
8191> |
rmac MACADDR
}
[
ttl
<1-64>]
To display the information of CFM OAM, use the following command.
Command
Mode
Description
show onu cfm mep
[
gpon
OLT_ID
]
Enable
Global
Shows the information of MEP configured on an OLT.
show
onu
cfm mip
[
gpon
OLT_ID
]
Shows the information of MIP configured on an OLT.
show onu cfm ma
[<1-65535>]
Global
Shows the information of MA.
show onu cfm md
[
DOMAIN
]
Shows the configured MD and level.
show onu cfm mep
[
ONU_ID
]
Interface
[GPON]
Shows the status of MEP configured on an ONU.
show onu cfm mep ccm-db
ONU_ID
{
uni eth PORT
|
ani
mapper
NUMBER
}
mep-id
MEP_ID
Shows the information of a MEP in the CCM database.
show onu cfm mip
[
ONU_ID
]
Shows the status of MIP configured on an ONU.
13.2.21
ONU Firmware Upgrade
The V8102 provides the remote ONU (ONT) upgradeability. This feature allows the sys-
tem administrators not to offer the local service for a single ONU (ONT) upgrade at the
customer premise. To upgrade an ONU (ONT) successfully, you need to download a new
ONU (ONT) firmware in the system.