User Manual
UMN:CLI
V8102
53
face unit. Use a hyphen to designate a range of ports.
(e.g. 0/1-4 or 0/1-0/4)
3.1.4.2
GPON Interface Mode
The GPON Interface mode contains commands for configuring the GPON interface. You
can open this
Interface Configuration
mode when at least one SIU_GPON16 module is
installed in the V8102 chassis.
To open
GPON Interface Configuration
mode, enter the
interface gpon
command, then
the system prompt will be changed from SWITCH(config)# to SWITCH(config-if[GPON])#.
Command
Mode
Description
interface gpon IFPORT
Global
Enters the
Interface Configuration
mode to configure
an GPON type interface.
IFPORT: physical interface port number
(SLOT#/PORT#, e.g. 1/1, 2/1)
IFPORT-RANGE: list of valid ports per GPON interface
unit. Use a hyphen to designate a range of ports.
(e.g. 1/1-16 or 1/1-1/16)
interface range gpon
IFPORT-
RANGE
3.1.4.3
Management (MGMT) Interface Mode
You can configure the system to be accessed remotely by Telnet. Firstly, you have to in-
stall the SFU module in the central slot of the chassis. The V8102 has a management
port (MGMT) and console port on the front panel of SFU module.
To open
Interface MGMT Interface Configuration
mode, enter the
interface management
command, then the system prompt will be changed from SWITCH(config)# to
SWITCH(config-if[mgmt])#.
Command
Mode
Description
interface
management
Global
Opens
MGMT Interface Configuration
mode to specify
an IP address.
3.1.4.4
VLAN Database Mode
To create a VLAN, the VLAN Database mode contains the commands. To open
VLAN Da-
tabase
mode, enter the
vlan database
command, then the system prompt will be
changed from SWITCH(config)# to SWITCH(config-vlan)#.
Command
Mode
Description
vlan database
Global
Opens
VLAN Database
mode.
vlan VLANS
VLAN
Database
Creates a VLAN by assigning VLAN ID:
VLANS: VLAN ID (2-4094, multiple entries possible)