UMN:CLI
User Manual
V8102
326
Therefore, the V8102 is configured to decide the way of packet route in order to distribute
(or forward) packets to the member port effectively when packets enter. It is decided with
Source IP address, destination IP address, source MAC address, destination MAC ad-
dress and the user could get information of packets to decided packet route.
dstip
is des-
tination IP address and
dstmac
means destination MAC address.
For the V8102, a source destination MAC address is basically used to decide packet
route.
After configuring an LACP aggregator, you should configure the distribution mode. The
following is the command for configuring the distribution mode of the LACP aggregator.
Command
Mode
Description
channel-group distmode
{
srcmac
|
dstmac
|
srcdstmac
|
srcip
|
dstip
|
srcdstip
}
Interface
[CG]
Configures the distribution mode of the LACP aggrega-
tor:
srcmac: source MAC address
dstmac: destination MAC address
srcdstmac: source/destination MAC address (default)
srcip: source IP address
dstip: destination IP address
srcdstip: source/destination IP address
To delete a configured distribution mode, use the following command.
Command
Mode
Description
no
channel-group
distmode
AGGREGETIONS
Interface
[CG]
Deletes a configured distribution mode.
9.2.2.3
Priority of Switch
In case the member ports of connected switches are configured as Active mode (LACP
system enabled), it is required to configure which switch would be a standard for it. For
this case, the user could configure the priority on switch. The following is the command of
configuring the priority of the switch in LACP function.
Command
Mode
Description
channel-group system priority
<1-65535>
Global
Sets the priority of the switch in LACP function, enter
the switch system priority. (default: 32768)
To delete the priority of configured switch, use the following command.
Command
Mode
Description
no channel-group system priori-
ty
Global
Clears the priority of the configured switch.
i
