User Manual
UMN:CLI
V8102
805
ONT Provisioning Process
①
ONT Provisioning Tool & JRE Installation
: Install JRE (version 1.6) and provision-
ing tool (ONTProvisionTool.exe) to FTP server. Create a new XML configuration file
and modify the ONT settings for ONT provisioning. The ONT configuration parame-
ters can be changed or saved in XML.
②
File Transfer from FTP server to ONT
: For the ONT configuration file (XML file)
transfer, the ONT provisioning-related commands should be executed on the OLT.
The OLT is capable to relay the user-defined XML file from the FTP server to the acti-
vated ONTs.
③
ONT Activation
④
Receive XML configuration file from FTP server
: The ONT receives the ONT ser-
vice configuration file in XML from FTP server. The new service settings are assigned
to this ONT.
⑤
Send File Transfer Message
: On the OLT side, the OLT can monitor a file transfer
status by receiving the messages (“File transfer in progress”, “File transfer complete”,
“Remote failure”, “Local failure”) from ONT.
IP-Path Management
To configure the ONT provisioning feature and specify a FTP server and GPON provision-
ing file, use the following command.
Command
Mode
Description
onu
mgmt-mode
ip-path
ONU_ID ftp id ID password
[
PASSWORD
]
Interface
[GPON]
Sets an user name and password to access FTP server
for GPON ONT provisioning.
ONU-ID: 1-128 or ONU serial number
ID: user name
PASSWD: password
onu
mgmt-mode
ip-path
ONU_ID
uri
URI
file
{
FILE_NAME
|
none
}
Specifies a FTP server and ONT provisioning file (XML
file) name.
URI: FTP server address
FILE_NAME: ONT provisioning file name
none
: The file name is named after GPON serial number
of each ONT. The ONT is supposed to ask .xml provi-
sioning file named after its own GPON serial number. If
selecing this option, it is necessary that the FTP server
has each .xml provisioning file corresponding to each
ONT.