User Manual
UMN:CLI
V8102
71
The commands that are used in low level can be also used in the higher level. For exam-
ple, the command in level 0 can be used in from level 0 to level 14.
The commands should be input same as the displayed commands by
show list
. There-
fore, it is not possible to input the commands in the bracket separately.
SWITCH#
show list
clear arp
clear arp IFNAME
clear ip arp inspection statistics (vlan VLAN_NAME|)
clear ip bgp * in
clear ip bgp * in prefix-filter
clear ip bgp * ipv4 (unicast|multicast) in
clear ip bgp * ipv4 (unicast|multicast) in prefix-filter
clear ip bgp * ipv4 (unicast|multicast) out
clear ip bgp * ipv4 (unicast|multicast) soft
clear ip bgp * ipv4 (unicast|multicast) soft in
clear ip bgp * ipv4 (unicast|multicast) soft out
clear ip bgp * out
clear ip bgp * soft
clear ip bgp * soft in
(Omitted)
It is not possible to input
clear ip bgp * ipv4 unicast in
. You should input like
clear ip
bgp * ipv4
{
unicast
|
multicast
}
in
. The commands starting with the same character are
applied by inputting only the starting commands. For example, if you input
show
, all the
commands starting with
show
are applied.
To delete a configured security level, use the following command.
Command
Mode
Description
no privilege
Global
Deletes all configured security
levels.
no privilege view
level
<0-15> {
COMMAND
|
all
}
Delete a configured security
level on each mode.
no privilege enable level
<0-15> {
COMMAND
|
all
}
no privilege configure level
<0-15> {
COMMAND
|
all
}
no privilege dhcp-option-format level
<0-15> {
COMMAND
|
all
}
no privilege dhcp6-option-format level
<0-15> {
COMMAND
|
all
}
no privilege dhcp6-pool level
<0-15> {
COMMAND
|
all
}
no privilege interface level
<0-15> {
COMMAND
|
all
}
no privilege flow level
<0-15> {
COMMAND
|
all
}
no privilege vrrp level
<0-15> {
COMMAND
|
all
}
no privilege policer level
<0-15> {
COMMAND
|
all
}
no privilege policy level
<0-15> {
COMMAND
|
all
}
no privilege rip level
<0-15> {
COMMAND
|
all
}
no privilege bgp level
<0-15> {
COMMAND
|
all
}