UMN:CLI
User Manual
V8102
248
After creating a standard MAC address-based ACL entry, the prompt changes from
SWITCH(config)# to SWITCH(config-ext-macl])#.
To configure an extended MAC address-based ACL entry, use the following command.
Command
Mode
Description
[<1-2147483647>] {
deny
|
permit
}
{
any
|
host HOST-MACADDR
|
MACADDR MACADDR-MASK
} {
any
|
host HOST-MACADDR
|
MACADDR
MACADDR-MASK
}
{
TYPE-NUM
|
aarp
|
amber
|
any
|
dec-spanning
|
decnet-iv
|
diagnostic
|
dsm
|
etype-
6000
|
etype-8042
|
lat
|
lavc-sca
|
mop-console
|
mop-dump
|
msdos
|
mumps
|
netbios
|
vines-echo
|
vines-ip
|
xns-idp
}
cos
{<0-7> |
any
}
MAC
ACL
Mode
Specifies a deny or permit statement of the MAC ad-
dress-based ACL.
1-2147483647: sequence number
any: any source/destination MAC address
host: A single source/destination MAC
HOST-MACADDR: host MAC address
MACADDR: source/destination MAC address
MACADDR-MASK: source/destination MAC address
mask
TYPE-NUM: Ethernet type (ex: 0x0800 for IPv4)
remark LINE
Writes comments for this MAC address-based ACL.
LINE: access list entry comments up to 100 characters
no
<1-2147483647>
Deletes an entry of the MAC address-based ACL.
no
{
deny
|
permit
}
{
any
|
host HOST-
MACADDR
|
MACADDR MACADDR-
MASK
}
{
any
|
host
HOST-
MACADDR
|
MACADDR
MACADDR-
MASK
} {
TYPE-NUM
|
aarp
|
amber
|
any
|
dec-spanning
|
decnet-iv
|
diagnostic
|
dsm
|
etype-6000
|
etype-8042
|
lat
|
lavc-sca
|
mop-
console
|
mop-dump
|
msdos
|
mumps
|
netbios
|
vines-echo
|
vines-ip
|
xns-idp
}
cos
{<0-7> |
any
}
no remark LINE
To display the configured extended MAC address-based ACL, use the following command.
Command
Mode
Description
show mac access-list
{<700-799> |
<1100-1199> |
WORD
}
Global
Shows the configured extended MAC address-based
ACL.
700-799: extended MAC access-list number
1100-1199: extended MAC access-list number (ex-
panded range)
WORD: access list name
