User Manual
UMN:CLI
V8102
901
To display a configured IP address, subnet mask and gateway, use the following com-
mand.
Command
Mode
Description
show
Boot
Shows a currently configured IP address, subnet mask
and gateway.
The configured IP address, subnet mask and gateway on the MGMT interface are limited
to the boot mode only!
The following is an example of configuring an IP address, subnet mask and gateway on
the MGMT interface in the boot mode.
Boot>
ip
10.27.41.83
Boot>
netmask
255.255.255.0
Boot>
gateway
10.27.41.254
Boot>
show
IP
= 10.27.41.83
GATEWAY
= 10.27.41.254
NETMASK
= 255.255.255.0
MAC
= 00:d0:cb:00:0d:83
MAC1
= ff:ff:ff:ff:ff:ff
Boot>
Step 3
Download the new system software via TFTP using the following command.
Command
Mode
Description
load
{
os1
|
os2
}
A.B.C.D FILE-
NAME
Boot
Downloads the system software.
os1 | os2: the area where the system software is stored
A.B.C.D: TFTP server address
FILENAME: system software file name
To verify the system software in the system, use the following command.
Command
Mode
Description
flashinfo
Boot
Shows the system software in the system.
To upgrade the system software in the boot mode, TFTP server must be set up first! Us-
ing the
load
command, the system will download the new system software from the serv-
er.
The following is an example of upgrading the system software stored in
os1
in the boot
mode.
Boot>
load os1
10.27.41.82 V8102_SFU.3.01-1032.x
TFTP from server 10.27.41.82; our IP address is 10.27.41.83
Filename 'V8102_SFU.3.01-1032.x'.
Load address: 0xffffe0
Loading: #####################################################################
#####################################################################
!
!