•
icmp-ping
•
icmp-ping-timestamp
•
udp-ping
•
udp-ping-timestamp
To configure RPM probes and enable hardware timestamping:
1.
Specify the probe owner:
[edit services rpm]
user@switch#
set probe owner
2.
Specify a test name. A test represents the range of probes over which the standard
deviation, average, and jitter are calculated.
[edit services rpm probe
owner
]
user@switch#
set test test-name
3.
Specify the packet and protocol contents of the probe:
[edit services rpm probe
owner
test
test-name
]
user@switch#
set probe-type type
4.
Specify the destination IPv4 address to be used for the probes:
[edit services rpm probe
owner
test
test-name
]
user@switch#
set target address address
5.
Specify the number of probes within a test:
[edit services rpm probe
owner
test
test-name
]
user@switch#
set probe-count count
6.
Specify the time, in seconds, to wait between sending packets:
[edit services rpm probe
owner
test
test-name
]
user@switch#
set probe-interval interval
7.
Specify the time, in seconds, to wait between tests:
[edit services rpm probe
owner
test
test-name
]
user@switch#
set test-interval interval
8.
Specify the source IP address to be used for probes. If the source IP address is not
one of the switch’s assigned addresses, the packet uses the outgoing interface’s
address as its source.
[edit services rpm probe
owner
test
test-name
]
user@switch#
set source-address address
9.
Specify the value of the Differentiated Services (DiffServ) field within the IP header.
The DiffServ code point (DSCP) bits value must be set to a valid 6-bit pattern.
[edit services rpm probe
owner
test
test-name
]
user@switch#
set dscp-code-point dscp-bits
10.
If you are using ICMP probes, specify the size of the data portion of ICMP probes:
[edit services rpm probe
owner
test
test-name
]
Copyright © 2010, Juniper Networks, Inc.
3712
Complete Software Guide for Junos
®
OS for EX Series Ethernet Switches, Release 10.3
Summary of Contents for JUNOS OS 10.3 - SOFTWARE
