CHAPTER 5 TPCL-LE MODE (INTERFACE COMMANDS)
B-EP
Series
5-200
Detailed status in the compatible mode for the B-SP series
“00”: Normal state
“01”: Cover open state
“02”: Operating
(including wait for strip, pause state, wait for battery
recovery, wait for head temperature reduction, wait for
motor temperature reduction, writable character/PC
command save mode)
“06”: Command syntax error (including Ir packet error)
“09”: Normal issue end + Label end
“11”: Paper jam
“13”: Label end
“15”: Cover open error
“17”: Broken head dots error
“18”: Thermal head excessive temperature
(including ambient temperature error, abnormal battery
temperature, battery excessive temperature)
“36”: Low battery
“37”: Charging error
“39”: Bluetooth setup error (including initialization error)
(“40”: Normal issue end) Response status for automatic status
transmission
(“41”: Normal feed end) Response status for automatic status
transmission
“50”: Flash ROM write error
“51”: Flash ROM erase error
“54”: Flash ROM storage area full state
Notes
(1)
The status is returned only to the interface which sent this command.
(2) After the code of the Bit Map Writable Character Command ([ESC] XD) or Graphic
Command ([ESC] SG) is received, the Status Request Command is not processed until
the printer receives the data specified for the type of data.
(3)
After receiving the Status Request Command, there may be a maximum of 20-msec.
delay until the printer sends a status.
(4)
At least, a 20-msec. interval must be given between the transmissions of the Status
Request Command. If the next Status Request Command is transmitted within 20
msec., the printer may fail to receive it.
(5)
The status "09” is valid only when the compatible mode for the B-SP series is enabled in
the SYSTEM mode. In a mode other than the compatible mode, it indicates the label
end.
Example
[ESC] WS [LF] [NUL]
