CHAPTER 3 INTERFACE
B-EP
Series
3-45
• Contents of the status
[LABEL, RECEIPT or ESC/POS mode]
Data to be sent (Fixed at 5 bytes)
STX
Printer ID
Printer status Battery status
02H xxH
xxH xxH
xxH
• Printer ID ......... 2-byte hex data (in order from High to Low)
• Printer status ... Printer status is indicated in 1-byte data.
00H: Normal state (idling)
01H: Cover open state
02H: Command syntax error (including Ir packet error)
03H:
Paper
jam
04H:
Label
end
05H: Cover open error
06H: Broken head dots error
07H: Thermal head excessive temperature
08H: Flash ROM write error
09H: Flash ROM erase error
0AH: Low battery (Print failure)
0BH:
Operating
0CH: Communication error * In the RECEIPT mode or for RS-232C connection only
0DH: Normal end + Label end
(See
NOTE
.)
0EH: Flash ROM storage area full state
0FH: Wait for strip * In the LABEL mode only
10H: Normal issue end
14H:
Pause
state
19H: Ambient temperature error
32H: Abnormal battery temperature
33H: Battery excessive temperature
37H:
Charging
error
38H: Bluetooth setting successfully completed
39H: Bluetooth setup error (including initialization error)
45H: Wait for battery recovery
46H: Wait for head temperature reduction
47H: Wait for motor temperature reduction
55H: Writable character/PC command save mode
NOTE:
In the LABEL mode, this is a state when the printer runs out of labels, after the
effective print length is printed. In the RECEIPT mode, this status is returned
to the host, when the printer runs out of labels, after a receipt is issued.
