Chapter 8: Using the Command Line Interface
439
Example - Inlet Naming
The following command assigns the name "AC source" to the inlet 1. If
your PX device contains multiple inlets, this command names the 1st
inlet.
config:#
inlet 1 name "AC source"
Overcurrent Protector Configuration Commands
An overcurrent protector configuration command begins with
ocp.
The
command configures an individual circuit breaker or fuse which protects
outlets.
Changing the Overcurrent Protector Name
This command names a circuit breaker or a fuse which protects outlets
on your PX.
config:#
ocp <n> name "<name>"
Variables:
<n> is the number of the overcurrent protector that you want to
configure. The value is an integer between 1 and 50.
<name> is a string comprising up to 32 ASCII printable characters.
The <name> variable must be enclosed in quotes when it contains
spaces.
Example - OCP Naming
The command assigns the name "Email servers CB" to the overcurrent
protector labeled 2.
config:#
ocp 2 name "Email servers CB"
User Configuration Commands
Most user configuration commands begin with
user
except for the
password change command.
Summary of Contents for PX3-4000 series
