Chapter 8: Using the Command Line Interface
428
Modifying Role-Based Access Control Parameters
There are different commands for modifying role-based access control
parameters.
IPv4 commands
Enable or disable the IPv4 role-based access control feature:
config:#
security roleBasedAccessControl ipv4 enabled <option>
Determine the IPv4 role-based access control policy:
config:#
security roleBasedAccessControl ipv4 defaultPolicy <policy>
IPv6 commands
Enable or disable the IPv6 role-based access control feature:
config:#
security roleBasedAccessControl ipv6 enabled <option>
Determine the IPv6 role-based access control policy:
config:#
security roleBasedAccessControl ipv6 defaultPolicy <policy>
Variables:
<option> is one of the options:
true
or
false
.
Option
Description
true
Enables the role-based access control feature.
false
Disables the role-based access control feature.
<policy> is one of the options:
allow
or
deny
.
Policy
Description
allow
Accepts traffic from all IP addresses regardless of
the user's role.
deny
Drops traffic from all IP addresses regardless of
the user's role.
Summary of Contents for PX3-4000 series
