Chapter 8: Using the Command Line Interface
490
Setting the Serial Port Baud Rate
The following command syntax sets the CONSOLE baud rate (bps) of
the serial port labeled CONSOLE / MODEM on the PX device. Change
the CONSOLE baud rate before connecting it to any Raritan device,
such as Raritan's P2CIM-SER, through the serial port, or there are
communications errors. If you change the baud rate dynamically after the
connection has been made, you must reset the PX or power cycle the
connected Raritan device for proper communications.
config:#
serial baudRate <baud_rate>
Variables:
<baud_rate> is one of the CONSOLE baud rate options:
1200
,
2400
,
4800
,
9600
,
19200
,
38400
,
57600
,
115200
.
Note: The serial port bit-rate change is needed when the PX works in
conjunction with Raritan's Dominion LX KVM switch. The Dominion LX
only supports 19200 bps for communications over the serial interface.
Example
The following command sets the baud rate of the PX device's serial port
to 9600 bps.
config:#
serial baudRate 9600
Setting the History Buffer Length
This command syntax sets the history buffer length, which determines
the amount of history commands that can be retained in the buffer. The
default length is 25.
config:#
history length <n>
Variables:
<n> is an integer number between 1 and 250.
Summary of Contents for PX3-4000 series
