X20 system modules • Other functions • X20CM4810
X20 system User's Manual 3.10
2165
FrequencyBandConfigRead
Name:
FrequencyBand01ConfigRead to FrequencyBand32ConfigRead
Registers for reading the configuration of individual frequency bands.
Data type
Value
UINT
0 to 65,535
FrequencyBandDmgFreq60rpm
Name:
FrequencyBand01DmgFreq60rpm to FrequencyBand32DmgFreq60rpm
Standardized damage frequency at 60 rpm if the frequency band is configured as speed-dependent.
This is multiplied with the configured velocity data point in the module to calculate the frequency band.
The standardized damage frequency must be specified in 1/100.
Data type
Value
UINT
1 bis 65,535
FrequencyBandDmgFreq60rpmRead
Name:
FrequencyBand01DmgFreq60rpmRead to FrequencyBand32DmgFreq60rpmRead
Register to read the standardized damage frequency at 60 rpm for the individual frequency bands.
The standardized damage frequency is specified in 1/100.
Data type
Value
UINT
1 bis 65,535
FrequencyBandTolerance
Name:
FrequencyBand01Tolerance to FrequencyBand32Tolerance
If the frequency band is configured as speed-dependent, then this data point can be used to specify the frequency
band's width.
The FrequencyBandTolerance is subtracted once from the damage frequency calculated from the ActSpeed and
FrequencyBandDmgFreq60rpm to get the frequency band's lower frequency and added once to get the higher
frequency.
The tolerance must be specified in 1/100 Hz. Valid values are 1 to 65535.
Data type
Value
UINT
1 bis 65,535
FrequencyBandToleranceRead
Name:
FrequencyBand01ToleranceRead to FrequencyBand32ToleranceRead
Registers for reading the tolerance of individual frequency bands.
The tolerance is specified in 1/100 Hz.
Data type
Value
UINT
1 to 65,535
FrequencyBandLowerFrequency
Name:
FrequencyBand01LowerFrequency to FrequencyBand32LowerFrequency
Minimum frequency for calculating the frequency band if it is not speed-dependent.
The minimum frequency must be specified in 1/4 Hz.
Data type
Value
UINT
1 to 40,000
Summary of Contents for X20 System
Page 2: ......
