X20 system modules • Other functions • X20CM4810
X20 system User's Manual 3.10
2173
4.26.2.5.6.25 RmsHighFrequencyRef01-04
Reference (correct state) of the high frequency signal's root mean square used to calculate the Vdi3832 K(t) of
the high frequency signal.
This register is only available in Function model 0 - Standard.
4.26.2.5.6.26 RmsHighFrequencyRefCalculated01-04
Reference (correct state) of the high frequency signal's root mean square that was used to calculating the Vdi3832
K(t) of the high frequency signal.
This register is only available in Function model 0 - Standard.
4.26.2.5.6.27 RmsRawRef01-04
Reference (correct state) of the raw signal's root mean square for calculating the Vdi3832 K(t) of the raw signal.
This register is only available in Function model 0 - Standard.
4.26.2.5.6.28 RmsRawRefCalculated01-04
Reference (correct state) of the raw signal's root mean square that was used to calculate the Vdi3832 K(t) of the
raw signal.
This register is only available in Function model 0 - Standard.
4.26.2.5.6.29 SensitivitySensor01-04
The X20CM4810 always calculates the characteristic values based on a 100 mV/g sensor on the input. Other
sensors can be used by specifying the sensor resolution in mV/g for each channel on these data points. All cyclical
characteristic values are then automatically scaled to the correct sensor resolution by Automation Runtime. If this
parameter is changed, then the next measurement indicated by "DataToggleBit01" is invalid.
This register is only available in Function model 0 - Standard.
4.26.2.5.6.30 SensorConfig01
This register can be used to enable or disable the IEPE sensor supply for individual channels.
Bit
Description
15
1 = Function model 1 - Fast master
0 = Function model 2 - Slow master and Function model 254 - Bus controller
14
Buffer length (0 = 8192 bytes, 1 = 65535 bytes)
13-12
Reserved = 0
11
EnableVelocityCalculation for channel 4
10
EnableVelocityCalculation for channel 3
9
EnableVelocityCalculation for channel 2
8
EnableVelocityCalculation for channel 1
7-4
Reserved = 0
3
IEPE supply for channel 4 (0 = Off, 1 = On)
2
IEPE supply for channel 3 (0 = Off, 1 = On)
1
IEPE supply for channel 2 (0 = Off, 1 = On)
0
IEPE supply for channel 1 (0 = Off, 1 = On)
Table 763: SensorConfig01
EnableVelocityCalculation
This bit can be used to enable the calculation of all characteristic values calculated on the velocity spectrum
(1 = Calculation enabled).
If this calculation is not enabled, 0 is output for all characteristic values calculated on the velocity spectrum.
To maximize the precision of the characteristic values based on the acceleration spectrum, it is recommend-
ed to only enable this bit if the velocity signals are absolutely required.
4.26.2.5.6.31 SensorConfig01Read
Register for reading the current "SensorConfig01" configuration.
Summary of Contents for X20 System
Page 2: ......
