A4.3
Core Wait for Interrupt
Programmers can use the
Wait for Interrupt
(WFI) instruction to cause the core to enter a low-power
state.
Wait for Interrupt is a feature of the Armv8-A architecture that puts the core in a low-power state by
disabling most of the clocks in the core while keeping the core powered up. Apart from a small dynamic
power overhead on the logic to enable the core to wake up from WFI low-power state, this reduces the
power drawn to static leakage current only.
When executing the
WFI
instruction, the core waits for all instructions in the core to retire before entering
the idle or low power state. The
WFI
instruction ensures that all explicit memory accesses that occurred
before the
WFI
instruction in program order have retired. For example, the
WFI
instruction ensures that
the following instructions received the required data or responses from the L2 memory system:
• Load instructions.
• Cache and TLB maintenance operations.
• Store exclusive instructions.
In addition, the
WFI
instruction ensures that store instructions have updated the cache or have been issued
to the SCU.
While the core is in WFI low-power state, the clocks in the core are temporarily enabled without causing
the core to exit WFI low-power state, when any of the following events are detected:
• A snoop request that must be serviced by the core L1 Data cache.
• A cache or TLB maintenance operation that must be serviced by the core L1 Instruction cache, data
cache, or TLB.
• An APB access to the debug or trace registers residing in the core power domain.
Exit from WFI low-power state occurs when the core detects a reset or one of the WFI wake up events as
described in the
Arm
®
Architecture Reference Manual Armv8, for Armv8-A architecture profile
.
On entry into WFI low-power state,
STANDBYWFI
for that core is asserted. Assertion of
STANDBYWFI
guarantees that the core is in idle and low-power state.
STANDBYWFI
continues to
assert even if the clocks in the core are temporarily enabled because of an L2 snoop request, cache or
TLB maintenance operation, or an APB access.
STANDBYWFI
does not indicate completion of L2 memory system transactions initiated by the
processor. All Cortex
‑
A35 processor implementations contain an L2 memory system. This includes
implementations without an L2 cache.
A4 Power Management
A4.3 Core Wait for Interrupt
100236_0100_00_en
Copyright © 2015–2017, 2019 Arm Limited or its affiliates. All rights
reserved.
A4-62
Non-Confidential
Summary of Contents for Cortex-A35
