Defaults
none
Command
Modes
REDIRECT-LIST
Command
History
Version 9.4.0.0
Introduced on the MXL 10/40GbE Switch IO Module.
Version 8.4.2.1
Introduced on the C-Series.
Version 8.4.2.0
Introduced on the E-Series TeraScale.
seq
Configure a filter with an assigned sequence number for the redirect list.
Syntax
seq
sequence-number
{permit | redirect {
ip-address
}} {
ip-
protocol-number
|
protocol-type
} {
source mask
| any | host
ip-
address
} {
destination mask
| any | host
ip-address
} [bit]
[
operator
]{source-port
source-port
| source-port-range
start-
port - end-port
} {destination-port
destination-port
|
destination-port-range
start-port - end-port
}
To delete a filter, use the
no seq sequence-number
command.
Parameters
sequence-
number
Enter a number from 1 to 65535.
permit
Enter the keyword
permit
assign the sequence to the
permit list.
redirect
Enter the keyword
redirect
to assign the sequence to the
redirect list.
ip-address
Enter the
IP address
of the forwarding router.
ip-protocol-
number
Enter the keyword
ip-protocol-number
then the number
from 0 to 255 for the protocol identified in the IP protocol
header.
protocol-type
Enter one of the following keywords as the protocol type:
•
icmp
for internet control message protocol
•
ip
for any internet protocol
•
tcp
for transmission control protocol
•
udp
for user datagram protocol
source
Enter the IP address of the network or host from which the
packets were sent.
mask
Enter a network mask in /prefix format (/x).
Policy-based Routing (PBR)
1009
