Parameters
address
Enter the IPv6 RP address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zero.
group-address
group-address
mask
Enter the keywords
group-address
then the group address
in the x:x:x:x::x format and then the mask in /nn format to
assign that group address to the RP.
NOTE: The :: notation specifies successive hexadecimal
fields of zero.
override
Enter the keyword
override
to override the BSR updates
with static RP. The override takes effect immediately during
enable/disable.
NOTE: This option is applicable to multicast group range.
Defaults
none
Command
Modes
CONFIGURATION
Command
History
Version 9.2(0.0)
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The RP addresses are stored in the order in which they are entered. RP addresses
learned via BSR take priority over static RP addresses.
Without the override option, the BSR-advertised RPs updates take precedence over
the statically configured RPs.
ipv6 pim rp-candidate
Specify an interface as an RP candidate.
Syntax
ipv6 pim rp-candidate
interface
[
priority-value
]
Parameters
interface
Enter the following keywords and slot/port or number
information:
• For a Loopback interface, enter the keyword
loopback
then a number from 0 to 16383.
• For a Port Channel interface, enter the keywords
port-
channel
then a number.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
then the slot/port information.
• For a VLAN, enter the keyword
vlan
then a number from
1 to 4094.
1038
PIM-Sparse Mode (PIM-SM)
