in
Enter the keyword
in
to apply the ACL to incoming traffic.
out
Enter the keyword
out
to apply the ACL to the outgoing
traffic.
implicit-permit
(OPTIONAL) Enter the keyword
implicit-permit
to
change the default action of the ACL from implicit-deny to
implicit-permit (that is, if the traffic does not match the filters
in the ACL, the traffic is permitted instead of dropped).
vlan
vlan-id
(OPTIONAL) Enter the keyword
vlan
then the ID numbers of
the VLANs.
Defaults
Not enabled..
Command
Modes
INTERFACE
Command
History
Version 8.3.16.1
Introduced on the MXL 10/40GbE Switch IO Module
platform.
Usage
Information
You can assign one ACL (standard or extended ACL) to an interface..
NOTE: This command is
not
supported on the MXL Switch Loopback
interfaces.
When you apply an ACL that filters IGMP traffic, all IGMP traffic is redirected to the
CPUs and soft-forwarded, if necessary, in the following scenarios:
• on a Layer 2 interface — if a Layer 3 ACL is applied to the interface
• on a Layer 3 port or on a Layer 2/Layer 3 port
Related
Commands
ip access-list standard
— configures a standard ACL.
ip access-list extended
— configures an extended ACL.
show ip access-lists
Display all of the IP ACLs configured in the system, whether or not they are applied to an interface, and
the count of matches/mismatches against each ACL entry displayed.
Syntax
show ip access-lists [
access-list-name
] [interface
interface
]
[in]
Parameters
access-list-
name
Enter the name of a configured MAC ACL, up to 140
characters.
interface
interface
Enter the keyword
interface
then the one of the following
keywords and slot/port or number information:
Access Control Lists (ACL)
145